Free box pleat calculator: divide usable fabric into equal pleats, find fold depth and take-up, and list four crease marks for every pleat cell.
Box pleats reduce a flat fabric width by folding material underneath a visible central panel. This planner divides the usable width into equal cells and calculates four crease positions per cell for outward box pleats.
Enter the flat fabric width, the required width after folding and the pleat count. Both widths exclude edge seam allowances. The flat width must exceed the finished width; add any edge allowances outside these measurements when preparing the cutting pattern.
Read the table from the fabric's left edge. In each cell, bring the start edge rightward to the left outer crease and the end edge leftward to the right outer crease. Use the schematic to check the directions, then test-fold a cell in paper or scrap fabric to judge the visible spacing and bulk.
Exclude the edge seam allowances reserved outside the pleats.
Printed:
Schematic only; not a full-size cutting template.
1–2: Fold to the right · 3–4: Fold to the left
| Pleat number | Cell start | Left underfold crease | Left outer crease | Right outer crease | Right underfold crease | Cell end |
|---|---|---|---|---|---|---|
| 1 | 0 mm | 25 mm | 50 mm | 100 mm | 125 mm | 150 mm |
| 2 | 150 mm | 175 mm | 200 mm | 250 mm | 275 mm | 300 mm |
| 3 | 300 mm | 325 mm | 350 mm | 400 mm | 425 mm | 450 mm |
| 4 | 450 mm | 475 mm | 500 mm | 550 mm | 575 mm | 600 mm |
| 5 | 600 mm | 625 mm | 650 mm | 700 mm | 725 mm | 750 mm |
| 6 | 750 mm | 775 mm | 800 mm | 850 mm | 875 mm | 900 mm |
Method reference Sew4Home ↗
No. Enter only the width available for pleating and the finished span those pleats must occupy. Reserve side seam allowances outside the calculated cells, then add them to the cutting pattern. Otherwise part of the pleating width would be consumed by the seams.
Bring the cell start to the left outer crease at offset 2d, folding rightward around the crease at d. Bring the cell end to the right outer crease at C - 2d, folding leftward around C - d. All four listed positions are crease lines; the panel between the two outer creases remains visible.
It is max(0, twice the underfold depth minus the finished pitch). A positive value means the hidden folds extend across one another behind the visible panel. Inputs above R = 5F are rejected because the hidden folds would project beyond the finished span. Within the accepted range, the width calculation remains valid, but the extra layers can affect pressing and drape. Test the fold in your fabric rather than treating zero overlap as a required standard.