Free book case calculator for flat spines: size cover boards, spine piece and cloth, with joint gaps, turn-ins and panel placement coordinates.
A book case combines two cover boards and a spine piece under a covering material. This planner lays those parts out flat for a square-back book, with adjustable board thickness, board overhang, joint gaps and cloth turn-ins.
Measure the completed book block's height, width from spine to fore edge, and thickness. Enter the board thickness and chosen allowances. The board overhang is the amount beyond the block at the head, tail and fore edge; changing the joint gap changes the cover-board width in this convention.
The results give cutting dimensions and three panel positions measured from the cloth's top-left corner. The front board appears first in this flat layout, followed by the spine and back board. Dry-fit the actual block, boards and covering material to check opening movement and overhang before cutting or gluing.
Measure the completed block from spine to fore edge, without the cover boards.
Projection beyond the block at the head, tail and fore edge; also called the square.
Gap between the spine piece and each cover board; it also changes board width in this layout.
Extra cloth beyond each outer edge, folded around the boards.
Printed:
Schematic only; not a full-size cutting template.
1 · Front cover board2 · Spine piece3 · Back cover board
| Part | Horizontal offset | Vertical offset | Panel width | Panel height |
|---|---|---|---|---|
| Front cover board | 20 mm | 20 mm | 146 mm | 216 mm |
| Spine piece | 173 mm | 20 mm | 24 mm | 216 mm |
| Back cover board | 204 mm | 20 mm | 146 mm | 216 mm |
Method reference Guild of Book Workers · 2021 · p.19 ↗
Often called the square, it is the chosen projection of the boards beyond the book block at the head, tail and fore edge. This planner adds it at both ends of board height and once at the fore edge in the board-width equation. Choose it for your construction and verify it on a dry fit.
The chosen convention uses boardWidth = blockWidth + overhang + boardThickness - jointGap. A larger gap therefore reduces each board width by the same amount. With the other inputs fixed, those reductions cancel the two wider gaps in the total flat case width, while the panel positions change. This relationship applies to this layout convention, not every binding method.
No. Rounded and backed bindings involve spine curvature and shoulders that this flat layout does not represent. Use a method suited to that structure and measure the actual assembled block. Even for a square back, test the joint movement and cloth turn-ins before cutting.