Free bag gusset calculator for a closed rounded panel: find the inset stitch-line perimeter, cutting strip dimensions and corner marking positions.
A gusset strip joins the front and back panels of a bag and sets its depth. This planner sizes one strip around a closed rounded rectangle, using the stitch line inside the panel rather than the longer cut edge.
Enter the panel's outer cut width, height and corner radius, then the uniform seam allowance. The bag depth is the strip width between its two stitch lines. Enter the combined allowance for joining the strip ends just once.
Use the nine boundary marks to transfer the straight-to-curve transitions onto the strip. Measurements run clockwise from the top-left stitch-line tangent; strip marks start half the joining allowance in from the cut end. Check the resulting strip against a paper pattern before cutting fabric or leather.
Width between the strip's two stitch lines; edge seam allowances are added separately.
Combined allowance for both ends, split equally before the first and after the last mark.
Printed:
Schematic only; not a full-size cutting template.
Cut edgeStitch line
| Boundary mark | Distance along stitch line | Distance from strip cut end |
|---|---|---|
| 0 | 0 mm | 10 mm |
| 1 | 240 mm | 250 mm |
| 2 | 271.42 mm | 281.42 mm |
| 3 | 411.42 mm | 421.42 mm |
| 4 | 442.83 mm | 452.83 mm |
| 5 | 682.83 mm | 692.83 mm |
| 6 | 714.25 mm | 724.25 mm |
| 7 | 854.25 mm | 864.25 mm |
| 8 | 885.66 mm | 895.66 mm |
Method reference OpenStax ↗
Enter the outer cut panel dimensions and outer corner radius. The calculator moves inward by the seam allowance to obtain the stitch-line profile. Using stitch-line dimensions as the inputs would subtract the allowance twice and make the strip too short.
The input is the combined allowance for both strip ends. A value of 20 mm adds 20 mm to the perimeter, with 10 mm before the first stitch-line boundary mark and 10 mm after the last. If your joining method needs different allowances, determine their total before entering it.
No. The path here closes around all four sides, with four straight sections and four quarter-circle corners. A gusset that stops at an opening needs its own measured open stitch path and end treatment. Do not cut this full-perimeter strip on that assumption.