Free countertop calculator: turn counter length and depth into square metres or square feet, add a cut allowance and estimate material and fabrication cost.
A countertop is priced by area, not by length, and the depth is what turns a tape measure into a quote. Enter the total length of your counter runs and the depth front to back, and the calculator returns the area you need to order plus what the material and fabrication should cost.
Switch to imperial and the same fields take inches and a price per square foot, which is how fabricators in the United States quote granite, quartz and solid surface. Both area readouts are always shown together, so a metric drawing and an imperial quote can be compared directly.
The depth default is the standard kitchen worktop: a 60 cm (24 in) base cabinet plus a 1 to 1.5 in front overhang, giving 63 cm or 25.5 in. Island and peninsula tops are often deeper, and a bar top with a seating overhang is deeper still, so change the depth to match what you are actually buying.
The cut allowance is the extra area ordered for cuts, seams and edges. Ten percent suits a straight run; L-shaped and U-shaped kitchens with seams need more. If a fabricator has already quoted a finished area, set the allowance to zero.
Only the counters are measured here. A backsplash, sink or hob cut-outs, edge profiles and installation are separate line items unless the price you type already includes them.
Run the tape along the back edge of each counter where it meets the wall, add the runs together and enter that total as the length. Measure depth front to back at the deepest point, including the overhang past the doors. For an L-shape, add the two runs and subtract one depth so the corner is not counted twice, then raise the cut allowance to 15%. Measure the old top in place before it is removed, because cabinets are rarely perfectly square.
Ten percent covers a straight run with square ends. Use 15% for L- and U-shaped kitchens, seams, out-of-square walls and sink or hob cut-outs, and 20 to 25% for small pieces cut from a large veined slab. Enter zero if your fabricator quotes a finished templated area, so the estimate matches the invoice rather than the raw measurement.
Only if the price you enter includes them. Fabricators usually quote fabrication and installation by area, while the slab alone costs much less; mid-range granite installed has been quoted around US$60 to 100 per ft². Sink and hob cut-outs are often charged per cut-out, and a backsplash is a separate strip measured as its own length × height. Add those as separate calculations or line items.