SmartCalc
FinancialHealthHome & EngineeringMathematicsTime & DateConvertersEducationGeneratorsGeneral
  1. Home
  2. /Home & Engineering
  3. /Electrical, heating & energy
  4. /Resistor Color Code Calculator

Resistor Color Code Calculator

Free resistor color code calculator: choose the bands of a 4 or 5 band resistor and read its nominal resistance, tolerance and guaranteed value range.

Resistors carry colored bands instead of a printed number, because a printed number would rub off. This calculator reads those bands: pick the color of each band from left to right and it returns the nominal resistance, the tolerance that band guarantees, and the range the part is allowed to sit in.

A four band resistor uses two significant digits, a multiplier and a tolerance. A five band resistor, the usual marking for 1 % and tighter parts, uses three significant digits plus the multiplier and tolerance. The third digit field only appears when you select five bands.

The colors follow IEC 60062: black 0 through white 9 for the digits, the same colors as powers of ten for the multiplier, and gold and silver for the multipliers below one ohm. Gold, silver and an absent band are the three tolerance choices that are never digits.

Enter the bands in the order they are printed. A real resistor is read starting from the end where the outermost band stands alone; the tolerance band is usually set slightly apart from the others.

Your inputs

Four band resistors carry two significant digits, five band resistors three. General purpose film resistors are usually 4 band; 1 % and tighter parts are usually 5 band.
IEC 60062 tolerances: brown ±1 %, red ±2 %, green ±0.5 %, blue ±0.25 %, violet ±0.1 %, gray ±0.05 %, gold ±5 %, silver ±10 %, no band ±20 %.
The multiplier is a power of ten: black x1, brown x10, red x100, orange x1k, yellow x10k, green x100k, blue x1M, violet x10M, gray x100M, white x1G, gold x0.1 and silver x0.01.
Resistance
4.7 kΩ
Tolerance
5%
Minimum value
4.465 kΩ
Maximum value
4.935 kΩ

Frequently Asked Questions

How do I read a resistor color code?

Start at the end where the outermost band sits closest to the edge and read towards the middle. In a four band code the first two bands are the first two digits, the third is the multiplier and the fourth is the tolerance. In a five band code the first three bands are the digits, the fourth is the multiplier and the fifth is the tolerance.

What does a gold or silver band mean?

Gold and silver are never digits. As a multiplier, gold means multiply by 0.1 and silver by 0.01, which is how values below one ohm are marked. As a tolerance, gold is ±5 % and silver is ±10 %. A code with no tolerance band at all is ±20 %.

Why does my multimeter disagree with the calculated value?

The tolerance band is the guaranteed worst case, not the measured value, so a 4.7 kΩ ±5 % part may legitimately read anywhere from 4.465 kΩ to 4.935 kΩ. The meter's own error, the tolerance of its reference and contact resistance at the probes explain the rest. If the reading is far outside the printed range, check the band order first.

Related Calculators

Wire Size Calculator

Free wire size calculator for estimating copper conductor area from voltage, current, cable length, and permitted voltage drop.

→

Battery Life Calculator

Free battery life calculator: convert mAh and volts into watt-hours, then divide by your device's wattage to see how many hours one charge will last.

→

SmartCalc.top — Free online calculators. No registration required.

© 2026 SmartCalc.top